Avaya 1000 Series Configuration Manual page 280

Backup Interface-ISDN
Procedure steps
1. Enter Configuration Mode.
2. Enter Interface Mode.
3. Configure an IP address for the Ethernet interface.
4. Give a name to the ISDN interface.
5. Provide BRI link bandwidth.
6. Add encapsulation.
7. Borrow an IP address from the Ethernet interface.
8. Enter the isdn sub-tree.
9. Configure sub-tree commands.
10. Activate the ISDN interface.
Table 37: Variable definitions
Variable
<A.B.C.D>
<bundle_name>
<delay>
<encap_type>
<interface>
280 Avaya Secure Router 1000 Series Configuration Guide
configure terminal
interface <interface>
ip address <A.B.C.D>
interface bundle <bundle_name>
link bri <link-spec>
encapsulation <encap-type>
ip unnumbered <interface>
isdn
switch-type <type>
idle-timeout <timeout>
connect-delay <delay>
callednum <number>
tei <tei-type>
activate
The IP address.
The bundle name, maximum 8 characters.
The connect delay in seconds, in the range 1 to 60.
The encapsulation protocol. Only PPP is supported.
The interface name.
Value
December 2010