Avaya 1000 Series Configuration Manual page 275

7. Configure a route over the ISDN interface.
8. Verify the IP interfaces.
9. Display the ISDN statistics.
Avaya Secure Router 1000 Series Configuration Guide
tei point-to-point
tei-value 0
caller -
answer1 -
answer2 -
called-number 384010
spid1 3840200001
spid2 -
idle-timeout 5 minutes
connect-delay 10 seconds
keep-alive 10000 ms
disconnect-cause 17
tei point-to-point
tei-value 0
Router1/configure> ip route 20.1.1.0 24 wan1
Note:
You cannot use the peer IP address for this route. You must use the interface
name for routes dedicated to ISDN.
Router1> show ip interfaces wan1 (unit number 4)
Type: S/W LOOPBACK
Flags: (0x20074243) UP, UNNUMBERED_S, RUNNING,
MULTICAST-ROUTE
Internet Address: 2.2.2.1
Internet Netmask: 255.255.255.0
Internet Broadcast: 2.2.2.255
Maximum Transfer Unit: 1500 bytes
Mac Address: 00:50:52:b2:c8:04
_wan1 (unit number 5)
Type: PT2PT
Flags: (0x1a07c203) UP, UNNUMBERED, MULTICAST-ROUTE
RED is enabled
Maximum Transfer Unit: 1500 bytes
Mac Address: 00:50:52:b2:c8:05
Router1> show isdn statistics BRI channel 0
statistics :
--------------------------
call not yet established
BRI channel 1 statistics :
--------------------------
call not yet established
D channel statistics--------------------
Bytes Rx: 3062
Frames Rx: 509
Error Frames Rx: 0
Bytes Tx: 2050
Frames Tx: 510
Fail Tx: 0
ISDN as Primary Interface
December 2010 275