Avaya 1000 Series Configuration Manual page 277

1. Configure the ISDN switch type).
2. Reboot the router.
3. Verify that the switch type is correct:
4. Configure a primary WAN bundle (refer to the illustration above).
5. Configure a backup WAN bundle (refer to the illustration above).
6. Configure ISDN.
7. Verify the ISDN interfaces.
Avaya Secure Router 1000 Series Configuration Guide
Router1/configure> isdn switch-type basic-ni ISDN
Switch type changed. Please reboot the box for
this change to take effect.
Router1> show isdn global
ISDN Global Configuration
-------------------------
Switch Type: basic-ni
Interface Type: U Interface
Router1/configure> interface bundle wan1
Configuring new bundle
Router1/configure/interface/bundle wan1> link t1 1
Router1/configure/interface/bundle wan1>
encapsulation ppp
Router1/configure/interface/bundle wan1> ip
address 3.3.3.1 24
Router1/configure/interface/bundle wan1> exit
Router1/configure> interface bundle wan2
Configuring new bundle
Router1/configure/interface/bundle wan2> link bri
64
Router1/configure/interface/bundle wan2> encapsulation
ppp
Router1/configure/interface/bundle
wan2> ip address 2.2.2.1 24
Router1/configure/interface/
bundle wan2> exit
Router1/configure/interface/bundle wan2> isdn
Router1/configure/interface/bundle wan2/isdn>
callednum 384010
Router1/configure/interface/bundle
wan2/isdn> idle-timeout 5
Router1/configure/interface/
bundle wan2/isdn> connect-delay 10
Router1/configure/interface/bundle wan2/isdn>
spid1 3840200001
Router1/configure/interface/bundle
wan2/isdn> exit
Note:
Spid configuration is optional for most switch types, but not for basic ni.
Router1> show isdn interfaces
ISDN Information: wan1
--------------------------
caller -
answer1 -
ISDN as backup Interface
December 2010 277