Avaya 1000 Series Configuration Manual page 29

no snmp-enable
4. Configure the source address.
source-address {<A.B.C.D> | <interface-name>}
5. Enable snmp server.
snmp-enable
Table 5: Variable definitions
Variable
<A.B.C.D>
<interface-name>
Configuring SNTP source address
Use the following procedure to configure SNTP server source address for all services.
Procedure steps
1. To configure source addresses for a service, enter Configuration Mode.
configure terminal
2. Enter the sntp subtree
sntp
3. Configure the source address.
source-address {<A.B.C.D> | <interface-name>}
Table 6: Variable definitions
Variable
<A.B.C.D>
<interface-name>
Configuring Syslog source address
Use the following procedure to configure Syslog server source address for all services.
Procedure steps
1. To configure source addresses for a service, enter Configuration Mode.
configure terminal
2. Enter the system logging subtree.
system logging
3. Enter the syslog subtree.
Avaya Secure Router 1000 Series Configuration Guide
Specify source address by IP address.
Specify source address by interface name.
Specify source address by IP address.
Specify source address by interface name.
Value
Value
December 2010 29