Avaya 1000 Series Configuration Manual page 50

DHCP Server Configuration
f. If applicable, change the lease timer. The default is 3600 seconds; the range is from
g. Once the pool is configured, issue the commit command to activate the pool.
h. Configure relay agent(s). In this example the relay agent is 20.20.20.1 and the
i. To display DHCP server pool configurations, address bindings, statistics, etc. use
Below is another example of DHCP server configuration.
50 Avaya Secure Router 1000 Series Configuration Guide
config/term/ip/dhcps> pool floor3 exclude-range 10.10.10.1
10.10.10.10
config/term/ip/dhcps> pool floor3 exclude-range 10.10.10.200
10.10.10.255
0 (doesn't expire) to 4294967 seconds.
config/term/ip/dhcps> pool floor3 lease [duration in seconds]
config/term/ip/dhcps> pool floor3 commit
Note:
Once the pool is committed no changes can be made unless it is uncommitted:
config/term/ip/dhcps> pool pool3 no commit
network is 20.20.20.0.
config/term/ip/dhcps> relay 20.20.20.1 20.20.20.0
Note:
There is no CLI command to link a given relay agent to a given address pool; the
linking is done automatically through the IP address/network association.
the following commands respectively:
SR1000/config> show ip dhcps config
SR1000/config> show ip dhcps address pools
SR1000/config> show ip dhcps bindings
SR1000/config> show ip dhcps statistics
Note:
If the SR1000 fails/recovers, it does not keep track of the DHCP bindings which
were assigned before the router failed.
December 2010