are sent to the neighbor. If no response is received, a DOWN state is entered, where packet
frequency is reduced to that of the Poll Interval.
Configuring OSPF NBMA over Ethernet
Use the following procedure to configure OSPF NBMA over Ethernet. There are 3 main
components to configuring OSPF NBMA. First, you specify the interface network type. This is
followed by specifying neighbors and a poll interval.
Procedure steps
1. To configure OSPF NBMA, enter Configuration Mode.
2. Specify a router ID for OSPF.
3. Enable OSPF.
4. Configure the OSPF area.
5. Specify the network type.
6. Configure neighbors, repeating this step for each neighbor you want to add.
7. Configure the poll interval.
Table 35: Variable definitions
Variable
<A.B.C.D>
<areaid>
<interface>
<interval>
<type>
<X.X.X.X>
Avaya Secure Router 1000 Series Configuration Guide
configure terminal
router router-id <X.X.X.X>
router ospf
interface <interface> area <areaid>
network <type>
neighbor <A.B.C.D>
poll_interval <interval>
The IP address.
The OSPF area ID.
The interface to work with.
The poll interval.
The network type.
The router ID IP address.
OSPF NBMA over Ethernet
Value
December 2010
213