Multipath Examples - Avaya 1000 Series Configuration Manual

Multipath Multicast
Enabling HRW method
Enabling Cisco-
compatible method
Disabling Multipath
Display RPF selection
When multipath is disabled, Avaya selects the nexthop address with lowest ip address. For
equal cost routes the nexthops are stored in the increasing (ascending) order of IP address.
show ip rpf command displays the selected path, based on the configured multipath
method and the nexthops of the best route to the IP address passed.

Multipath Examples

The following examples illustrate how the multicast commands are used:
The following command enables compatibility between the Secure Router and equipment
running Cisco IOS.
Router/configure/ip/multicast> multipath mode cisco
The following command enables HRW compatibility.
Router/configure/ip/multicast> multipath
The following example shows how to see the reverse path forwarding information for the RP
at 201.1.1.99:
SR> show ip rpf 201.1.1.99
186 Avaya Secure Router 1000 Series Configuration Guide
Task
Router/configure/ip/multicast> multipath
Router/configure/ip/multicast> multipath
cisco
Router/configure/ip/multicast> no
multipath
Router/configure/ip/multicast> no
multipath cisco
SR>show ip rpf <addr> <addr> - source or RP
address
Command
December 2010