Downloading From The Dimm To The Printer - Ricoh G031 Service Manual

1.4.2 DOWNLOADING FROM THE DIMM TO THE PRINTER

The firmware on a DIMM card can be copied to the flash ROM inside the printer.
To install the firmware, use the printer's service tool menu as shown below.
NOTE: The printer cannot boot from a DIMM card.
1. Turn off the printer.
2. Plug the DIMM card into the printer control board.
3. Turn the printer on while pressing the "Online" and
"Menu" keys together, to enter the service tool menu.
4. Use the "arrow" key to select "DIMM to Memory".
5. Press the "Enter" key.
6. Press the "Form Feed" key. Then downloading starts.
7. This message shows that downloading has finished
successfully.
8. Turn off the printer.
9. Detach the DIMM card.
10. Turn the printer on again and enter the service mode.
NOTE: If SC2800 appears, you forgot to take the DIMM out.
11. Print the log print and check the controller firmware version.
12. Return to user mode.
NOTE: There are two ways to go back to user mode from the service mode.
1) Press the "Form Feed" key and the "Escape" key together. Then
initialization will start.
2) Turn the printer off then on.
SM A-19
USING A DIMM
Service Tool
1. Test Print
G031X532.WMF
Service Tool
5. DIMM to Memory
G031X541.WMF
5. DIMM to Memory
Sure?
G031X542.WMF
STINGER version
Wait
G031X543.WMF
STINGER version
Successfully
G031X544.WMF
G031/G032