Ricoh G031 Service Manual page 106

SERVICE PROGRAM MODE
Accessing the Required Program
Select each program level in sequence.
1. Scroll through the 1st level programs using the "Up/Down arrow" keys. Then
press the "Enter" key.
2. Scroll through the items in the next lowest level using the "Up/Down arrow"
keys. To go back to a higher level, press the "Escape" key.
Inputting a Value or Setting for a Service Program
1. Enter the required program mode as explained above.
NOTE: The setting appearing initially on the display is the current setting.
2. Select the required setting using the "Up/Down arrow" keys, then press the
"Enter" key.
NOTE: The previous value remains if the "Enter" key is not pressed.
3. Exit service mode.
G031/G032 4-4 SM