4.3 IC CARD BOOT SERVICE MODE
4.3.1 OVERVIEW
The IC card booting service menu is accessed only by booting from an IC card.
The IC card is prepared as a service tool.
NOTE: A blank IC card cannot be used to boot up the printer.
4.3.2 ENABLING AND DISABLING IC CARD BOOT SERVICE
MODE
To enter the service mode
1. Turn the printer off.
2. Turn on DIP SW 1 on the printer control board.
3. Plug the IC card into the IC card adapter, then connect it to the option bus
connector.
NOTE: The G031 has two option bus connectors. The left connector can only
be used for this function.
4. Turn the printer on. The IC card boot service menu will be displayed.
To exit the service mode
1. Turn the printer off.
2. Remove the IC card and IC card adapter.
3. Turn DIP SW 1 to off.
4. Turn on the printer again.
5. Then, the user menu will appear.
NOTE: Don't forget to return DIP SW1 to the off position. Otherwise the printer will
not boot.
SM
IC CARD BOOT SERVICE MODE
4-15
G031/G032