Ricoh G031 Service Manual page 263

2. Click the Byte Swap button.
3. Select the source file name (eg. P3card.rom) from the file list.
4. Enter the destination file name (eg. P3carddwn.rom).
NOTE: Any destination file name can be used. However, the recommended file
name is XXXdwm.rom. Using a standard naming system such as this
will prevent confusion later.
5. Click Enter then click Exit. In the source file directory, XXXdwn.rom is created
as the byte-swapped file.
Downloading to the DIMM card
The firmware can be downloaded either with the Windows SSU utility or using MS-
DOS. Any firmware already included on the DIMM card will be overwritten.
Stinger Service Utility
First, prepare the printer.
1. Turn off the printer.
2. Change DIP SW1 to ON on the printer control board.
3. Connect the IC card to the IC card adapter, then connect the adapter to the
option bus connector on the printer control board.
NOTE: G031 has two option bus connectors. The left side connector is used
for the downloading.
The IC card must contain firmware for the printer; a blank IC card will
not boot up the printer.
4. Plug the DIMM card into the printer control board.
5. Turn on the printer. Then the printer will boot from the firmware in the IC card.
• The service menu will appear as follows.
SM A-15
USING A DIMM
G031X540.PCX
Stinger Service
1. Update Firmwr
G031X537.WMF
G031/G032