CHECKING THE CONNECTIONS
3.8.2 CONNECTION BETWEEN PRINTER CONTROL BOARD
AND NETWORK INTERFACE BOARD
There are three ways to check the connection between the main printer control
board and the network interface board.
• Check that the configuration page includes Ethernet settings.
• Check the "NIB Setup" menu in the Host Interface menu on the machine's
operation panel.
• Print out the Network Interface Board Configuration Sheet with the network
information (see below).
3.8.3 PRINTING THE NETWORK INTERFACE BOARD
CONFIGURATION SHEET
NOTE: The NIB configuration sheet will be printed out once just after turning on for
the first time when the NIB is installed.
1. Install the network interface board.
2. Turn on the main switch and wait for a few minutes.
3. The configuration sheet will be printed automatically.
NOTE: If the printer does not print the network interface board configuration sheet,
check the NIB setup menu in the Host Interface menu (user program
mode). If this menu is not displayed, the NIB is not connected properly.
If any problem occurs during the above steps, reinstall the NIB and other options,
then set the machine up again and test it again.
G031/G032
3-6
12 March 1999
SM