Ricoh G031 Service Manual page 176

OPERATOR ERRORS
Memory Overflow
Message:
Memory Overflow
Definition:
There is not enough memory to print the data.
Reset Method:
If the "Auto Continue" feature is on or when the "Enter" key is pressed, the data
in the memory is printed out. To clear this message, change the print resolution
from 1,200 dpi to 600 dpi or 300 dpi, and try printing again. If the job cannot be
printed completely, you should increase the memory capacity.
Print Overrun
Message:
Print Overrun
Definition:
The data sent to the printer was too complex.
Reset Method:
Press "Enter" to print out the data sent to the printer. If you do not want to lose
any of the transferred data, set the "Page Protect" feature to "On" before
printing the job. If you cannot clear this message, simplify the print job.
NOTE: Make sure to return the "Page Protect" feature to "Off" after the print job.
With the "Page Protect" feature "On", printer performance might be
reduced.
Hard Disk Error
Message:
Error SC_2600
Definition:
Error in the optional HDD.
Reset Method:
Remove the HDD from the printer and turn the printer's main switch off and on.
Then try to do the print job again.
Network Interface Board Error
Message:
Error SC_2700
Definition:
Error in the optional network interface board.
Reset Method:
Remove the network interface board from the printer and turn the printer's main
switch off and on. Then try to do the print job again.
G031/G032 7-4 SM