Ricoh G031 Service Manual page 233

5. Enter the password programmed in the network interface card ("sysadm" is the
default), then click "OK".
6. After sending the flash ROM image file to the network interface card, the card
updates its firmware.
7. After the firmware has been downloaded, click "OK" to finish.
8. The Print Server Card then updates its flash ROM. The machine will print a
status report after the flash ROM update has finished.
CAUTION: Do not turn off the machine until after it prints a status sheet.
Recovery from Failed Download
If the firmware download using FTPDL has failed, use the FlashUP utility to recover
the NIB. This is because the NIB may no longer contain the IP parameters after a
failed download.
SM 10-15
FLASH ROM UPDATE
G031/G032