Ricoh G031 Service Manual page 123

G032
Downloading Procedure
1. Turn off the printer.
2. Change DIP SW1 to ON on the printer control board.
3. Attach the IC card to the IC card adapter, then plug the adapter into the option
bus connector.
NOTE: G031 has two option bus connectors. Only the connector on the left
side can be used for downloading.
4. Turn on the printer. The printer will boot from the firmware in the IC card.
NOTE: Don't use a blank IC card. Otherwise the printer will not boot up.
SM
DOWNLOADING NEW CONTROLLER SOFTWARE
Option Bus (CN2)
Flash Flash
R O M R O M
D I P S W 1
DIMM Slot
E E P R O M
Centronics I/F
IC Card Adapter
IC Card
4-21
D I P S W
1 4
C P U
A S I C
G031M503.WMF
G031/G032