Ricoh G031 Service Manual page 124

DOWNLOADING NEW CONTROLLER SOFTWARE
5. The service menu will appear as follows. Do the
following step by step.
NOTE: The term "Stinger" indicates either the G032
or G032 printer.
Press the "Enter" key.
Press the "Form Feed" key.
The counter on the display counts down to zero.
6. The above display shows that updating has finished.
7. Turn off the printer.
8. Detach the IC card and the IC card adapter.
9. Change DIP SW1 to off.
10. Turn the printer on and enter the service program mode.
11. Print the log print and check the controller firmware version.
12. Return to the user mode.
NOTE: There are two ways to go back to the user mode from the service mode.
1) Press the "Form Feed" key and the "Escape" key together. Then
initialization will start.
2) Turn the printer off and on.
3) If an error occurs, after initializing the printer for the first time after a
firmware update, it may be necessary to perform the update again.
G031/G032 4-22
Stinger Service
1. Update Firm
G031M509.WMF
1. Update Firm
Sure?
G031M529.WMF
Stinger Firm ver
Wait 62
G031M530.WMF
Stinger Firm ver
Successful
G031M531.WMF
SM