Ricoh G031 Service Manual page 99

The maintenance counter [C] shows the main motor work time counter (the unit is
5000 seconds).
Check the following:
• For the main printer control board, check that the machine prints the
configuration page fully.
• For the RAM SIMM, confirm that "Total Installed RAM" [D] on the printout
shows the size of the module just installed, plus 8 Mbytes (the base memory
on the board).
• For the hard disk, confirm that "Hard Disk" [E] printed on the configuration
page shows the size of the hard disk.
• For the NIB, confirm that "Network Card" [F] printed on the configuration
page shows the type of network card.
• For the PCL version of the printer control board, check "Firmware Version"
[A].
• For the software version of the engine control board, check "Engine Version"
[B].
If there are any problems with the above check items, reinstall the printer controller
and other options. Then set up the machine again and test it again.
SM
M o d e l N a m e
Reference
Firmware Version
Engine Version
Pages Printed
Maintenance Counter
Total Installed RAM
H a r d D i s k
N e t w o r k C a r d
D I M M C a r d
3-5
CHECKING THE CONNECTIONS
[A]
2.23.22
[B]
1.1
1 2 3 4 5 6
[C]
4 3 4 5 6
[D]
3 6 M B
[E]
8 1 5 M B
[F]
Ethernet
[G]
Attached
G031I500.WMF
G031/G032