Installation Procedure - Ricoh G031 Service Manual

HARDWARE INSTALLATION

2. INSTALLATION PROCEDURE

2.1 HARDWARE INSTALLATION
Refer to the base engine or printer controller installation instructions for how to
install the network interface board.
2.1.1 SERIAL NUMBER AND MAC ADDRESS
Check the serial number and MAC
(Media Access Control) address that are
printed on the network interface board
(NIB).
The serial number is a 6-digit number,
and is unique to each board.
The MAC address (LAN ADDR.) is a 12-
digit hexadecimal number. The upper 6
digits are always "0040AF", and the lower
6 digits are unique to each board.
2.1.2 STATUS SHEET
By default, the NIB (network interface board) prints a status sheet every time after
the machine is powered-up or the NIB has reset itself.
NOTE: Connect a network cable to the NIB before turning on the machine or
resetting the NIB. Otherwise, the machine will take several minutes to print
the status sheet, and the information on it may not be accurate.
Keep the status sheet with the machine, because it has the following information.
• Unit serial number
• Firmware version
• Network (MAC) address
• Network/Protocol information
G031/G032
S/N: X X X X X X
LAN ADDR: 0040AF X X X X X X
10-2
12 March 1999
G919I500.WMF
SM