4.3.4 SERVICE MENU TABLE
Menu Item
Update Firmware
Download Firmware
Copy to DIMM
Copy to CARD
Clear NVRAM
TEST Print
SM
Update controller firmware using an IC card.
For details, see the appendix, and "Downloading New Controller
Software" in this section.
Download firmware from a PC through a parallel cable.
See the appendix for details.
Download firmware to a DIMM card from a PC through a parallel
cable.
See the appendix for details.
Download firmware to an IC card from a PC through a parallel
cable.
See the appendix for details.
Clear the NVRAM
To clear the NVRAM, press the "Enter" key twice.
Normally, NVRAM clear should not be used.
Note: This resets all the settings stored in the NVRAM to their
default settings. This procedure is required only after
replacing the NVRAM chip.
Print controller generated test pattern (Factory use)
See the appendix for details.
4-17
IC CARD BOOT SERVICE MODE
Function
G031/G032