Ricoh G031 Service Manual page 109

Menu Level
Level 1 Level 2
Output Main Motor
Check
1,200 dpi
Motor
Polygon
Motor
Laser Enable
Charger ON
1,200 dpi
Charger ON
Development
Bias ON
1,200 dpi
Development
Bias ON
Registration
Clutch ON
(G031)
By-pass
Solenoid ON
Feed Clutch
ON
(G031)
Feed
Solenoid ON
(G032)
2nd Feed
Clutch ON
2nd Feed
Motor ON
3rd Feed
Clutch ON
(G031)
3rd Feed
Motor ON
(G031)
Fan Motor
Product
Name
Note:
1. The product name is stored in the NVRAM on the controller
board.
2. Macintosh printers use the product name as a printer name.
3. When the IC Card boot menu NVRAM clear is done, store the
product name again.
4. User settings stored in the NVRAM are reset when the product
name is changed.
SM
To check the outputs, press the
"Enter" key. Press the "Enter" key
again to stop the check.
The menu will go back to level 2
when the "Escape" key is pressed.
Note:
1. OK/NG are not displayed.
2. To prevent mechanical or
electrical damage, do not keep
an electrical component on for a
long time.
Charger: Charge roller
Plug and Play Select the product name
Model Name
Use the "
name. This name is used for the
plug and play name and is
indicated on the top of
configuration page and print log.
4-7
SERVICE PROGRAM MODE
Function
8 9
/ " keys to select the
Settings
G031/G032