Driven Face Bearing Replacement - Honda Motorcycle Service Manual

V-MATIC BELT DRIVE SYSTEM
Use pliers t o hook the springs to the shoes.
I
SHOE SqRlNG
Install the snap rings and washers or retainer plate onto the
pivot pins.
DRIVEN FACE BEARING REPLACEMENT
Remove the inner bearing.
NOTE
If the driven face has an oil seal at inner bearing side,
remove the oil seal first.
If a ball bearing is used on the inside, remove the snap
r i n ~ first then remove the bearina.
Remove the snap ring then drive out the outer bearing toward
the inner bearing side.
Drive a new outer bearing into place with the sealed end
toward the outside.
Install the snap ring securely.
Apply the specified amount of specified grease as shown.
SPECIFIED GREASE (Lithium Based Grease):
Mitsubishi HD-3
Nippon Sekiyu Lipanox Deluxe
3
ldemitsu Coronex 3
Sta-Lube MP #3141
Bel-Ray Moly Lube 126 EP#O
Date of Issue: Sep., 1988
o
HONDA MOTOR CO., LTD.
1 2- 13