Radiator Reserve Tank Removal/Installation; Water Pump Mechanical Seal Inspection; Water Pump Removal/Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
COOLING SYSTEM
RADIATOR RESERVE TANK
REMOVAL/INSTALLATION
Remove the shock absorber (page 18-8).
Remove the rear wheel (page 18-4).
Remove the radiator reserve tank mounting bolt [1].
Remove the radiator reserve tank [2] by releasing the
boss [3] from the frame.
Disconnect the siphon hose [4] and drain the coolant.
Installation is in the reverse order of removal.
Fill the system with the recommended coolant to the
upper level line (page 8-4).
Install the shock absorber (page 18-8).
WATER PUMP
MECHANICAL SEAL INSPECTION
Check the bleed pipe [1] of the water pump for signs of
coolant leakage.
• A small amount of coolant weeping from the bleed
pipe is normal.
• Make sure that there is no continuous coolant
leakage from the bleed pipe while operating the
engine.
Replace the water pump as an assembly if necessary.
REMOVAL/INSTALLATION
Remove the right crankcase cover.
– CRF1000/A (page 12-4)
– CRF1000D (page 13-52)
Remove the drain bolt [1] and sealing washer [2].
Remove the water pump cover bolts [3] and water
pump body [4].
8-10
[2]
[3] [4]
CRF1000/A: CRF1000D:
[1]
CRF1000D shown:
[1]/[2]
[1]
[1]
[4] [3]