Table of Contents
Advertisement
Specifying network settings from PageScope Light
3.9
Specifying network settings from PageScope Light
Access
PageScope Light for Pi4700e can be accessed directly from a Web browser.
1
Start the Web browser.
2
In the URL field, enter the IP address of the printer controller as shown
below.
http://<IP address of printer controller>/
(Example) When the IP address of the printer controller is
192.9.200.200:
http://192.9.200.200/
3
This causes PageScope Light for Pi4700e screen to appear.
Operation
PageScope Light for Pi4700e operation is identical to that for Internet Web
pages. Clicking a hot link jumps to the link destination, and the
buttons scroll through pages backwards and forward.
Forward
Logging In to the Admin Mode
After you log in to PageScope Light in the Admin Mode, you can change
the configuration of the Digital Copier settings.
1
Type the administrator password into the
initial default administrator password is sysadm. See "Preference" for
information about how to change the password.
2
Click the
3
When you want to log out, click the
Note
Log out is performed automatically if no operation is performed for
more than 10 minutes.
On the
ting screen. You must be able to input the correct password in order to
change
the same as the Admin Password you input on other tabs.
Pi4700e
Log-in
button to log in to the Admin Mode.
Network
tab, a password input text box appears on each set-
Network
tab settings. The password you should input here is
Admin Password
Log-out
button.
3
Back
and
box. The
3-23
Advertisement
Table of Contents
Troubleshooting
