Minolta PI4700E User Manual page 406

Setting Up IP Parameters
Note
ARP can be used to assign an IP address only. Other IP parameters
must be set using Telnet or a Web browser. For details, see "12.8 Us-
ing Telnet to Make Settings" (p. 12-61) and PageScope Light for
Pi5501 Operator's Manual.
There are problems with the ARP command in earlier versions of Win-
dows 95, so the command may not function properly if the ARP entry
is blank. To check for and prevent such problems, enter the following
at the MS-DOS prompt.
arp -a
If the ARP entry is blank, ping another valid device on the network as
shown below.
ping <valid IP address for device other than the Net-
work Card>
Next, perform the above procedure starting from step 2.
You cannot use ARP to assign an IP address if the Network Card has
already been assigned an IP address by ATIP.
Pi4700e
12
12-55