Table of Contents
Advertisement
UNIX Configuration
6
The printcap entries you have made up to this point appear on the dis-
play and the script confirms whether you want the entries written into
the
/etc/printcap
cap and then press
press
tries.
<printer name> | Print Server Card printer:\
:lp=/dev/<printer name>:\
:if=/usr/nic/infilter:\
:sd=/usr/spool/<printer name>:
7
This completes the installation. In response to the message about
whether you want to install another printer, input
press
Like all BSD systems, ULTRIX uses the
printer. The interface to the installation script is the same for all BSD sys-
tems, but the printcap entry is different.
HP-UX System
1
Type the following command to run the installation script.
nicinst
The script automatically downloads the appropriate Network Card util-
ities for your system and displays questions to prompt you for the in-
formation it needs.
2
What is the node name of the Print Server Unit?
Type the host name recorded in /etc/hosts. For example, type
fast
and then press
3
What is the printer name?
Type the printer name and press
4
Here, the script displays the information you have input up to this point.
Node name of the Print Server Card: printfast
Printer name to be used: <printer name>
The printer is attached on: PORT 1
Check these settings and make sure they are correct. If they are cor-
rect, type
Pi4700e
file. Type
. If you do not want them added, type no,
Enter
and then manually make the required changes to the en-
Enter
.
Enter
.
Enter
yes
and press
Enter
yes
if you want the entries added to print-
/etc/printcap
.
Enter
. Otherwise, type
12
yes
or
no
and then
file to configure a
print-
no
and press
.
Enter
12-45
Advertisement
Table of Contents
Troubleshooting
