Table of Contents
Advertisement
Peer-to-Peer Printing with TCP/IP
Configuration Procedure (Windows NT 4.0)
1
Install TCP/IP under Windows NT 4.0.
Refer to the applicable Windows documentation for more information.
2
Assign the IP parameters.
See "3.2 Specifying the IP Address From the Printer's Touch Panel"
(p. 3-2) for more information.
3
Install the IP Peer-to-Peer Printing Program.
Use the IP Peer-to-Peer Printing Program for peer-to-peer printing.
See "3.4 Peer-to-Peer Printing Program (Windows)" (p. 3-8) for more
information.
4
Use the procedure below to install the printer.
Installing the printer (Windows NT 4.0)
1
On the
2
Double-click
the default printer.
See "2 Installing the Printer Driver" (p. 2-1) for details about how to in-
stall it.
3
Right-click the new printer icon and select
4
Display the
5
From the
Digital Copier IP address is displayed.
6
Click the
7
Right-click the printer icon again to display its Properties dialog box,
display the
8
If the test prints normally, complete the procedure by clicking
close the Properties dialog box.
After you finish installing a printer with the above procedure, you can use
it just as you would any standard local printer. The printer can also be
used as a network printer by other Windows computers on your network
whose Windows NT 4.0 systems are configured the same way as de-
scribed above.
Pi4700e
Start
menu, point to
Add Printer
and install the printer. Make the new printer
Ports
tab.
Print to the following port(s)
button of the Properties dialog box to close it.
OK
General
tab, and then perform a Test Print operation.
Settings
and then click Printers.
Properties
list, select the port where the
3
from the menu.
OK
to
3-7
Advertisement
Table of Contents
Troubleshooting
