Troubleshooting; Led Status Indicators - Minolta PI4700E User Manual

8
8.8

Troubleshooting

This chapter explains the Network Card's LED status indicators and tells
you what to do when experiencing problems with the Network Card. If the
information presented here does not solve your problem, contact your
nearest Support Center or Technical Service Representative.

LED Status Indicators

The Network Card has two LED status indicators amber and green in col-
or.
The amber LED shows the progress of normal print jobs. It flashes while
the Network Card is sending or receiving data, and goes out when there
is no data send or receive operation in progress.
The green LED shows normal Network Card operation, as described in
the table below.
LED Operation
Green LED lit
Green LED flashes 3
times, then remains lit
Green LED flashes
quickly
Green LED flashes 4
times, then pauses
Amber LED flashes at
short interval for 10
seconds. Amber LED
goes out, green LED
flashes continuously.
Green LED flashes
slowly
Green LED and amber
LED flash alternately
8-46
Digital Copier Sta-
Network Card Status
tus
Power on Self-test in progress
Print job standby Normal operation
Self-test finished Prints status page
Self-test in progress RAM abnormality detected
Self-test in progress Ethernet hardware self-test
failed. Check your network.
Flash memory self- Checksum test failed. Auto-
test in progress matically enters download
mode and waits for flash
memory refresh.
After power up, goes Broken connection between
into print job standby NetWare and file server
after a short while.
Power up sequence Factory initial default reset
complete complete. Power down and
move jumper JP2 to OFF po-
sition. See "Resetting to Fac-
tory Initial Defaults".
Troubleshooting
Normal/
Abnormal
Normal
Normal
Normal
Abnormal
Abnormal
Abnormal
Abnormal
Abnormal
Pi4700e