Minolta PI4700E User Manual page 282

Jumper switch setting
NVRAM. Reset the Network Card before moving the printer to another en-
vironment or any other time is becomes necessary to reconfigure it to suit
another environment.
Network Card Reset Procedure
1
Power down the Digital Copier and unplug it from its power outlet.
2
Disconnect the network cable from the Network Card.
3
Remove the Network Card from the printer by performing the steps in
Setup Instructions in reverse.
4
Locate the reset jumper switch (labeled OP2) on the Network Card.
See the illustration under "Network Card and Jumper Pin Positions".
5
Change the OP2 jumper switch to its
1 and 2).
6
Use the procedures in Setup Instructions to re-install the Network
Card. Do not connect the network cable to the Digital Copier at this
time.
7
Plug in the Digital Copier and power it up.
The Network Card performs a self-test, indicated by the green LED
flashing three times, following by the green LED and amber LED flash-
ing alternately. After the green and amber LEDs start to flash, power
down the Digital Copier and unplug it from its power outlet.
8
Remove the Network Card from the Digital Copier again.
9
Return the OP2 jumper switch to pins 2 and 3.
10
Use the procedures in Setup Instructions to re-install the Network
Card.
Pi4700e
FACT position (OP2 set to pins
8
8-51