Using Telnet To Make Settings; Establishing A Telnet Connection - Minolta PI4700E User Manual

Using Telnet to Make Settings

12.8 Using Telnet to Make Settings
In addition to the MAP and Web browser combination for making settings,
this Network Card also supports use of Telnet for setting up the environ-
ment. Network Card settings can be make from a Telnet client platform.
The following settings can be made over a Telnet connection.
G IP parameter changes
G LPD settings
G
Protocol changes
G Unit reset
G
Factory setting restore
G
Password changes
Note
The Network Card must be assigned a valid IP address before you can
use a Telnet connection to make settings. Also, the computer you are
using for the Telnet connection must have TCP/IP enabled, and must
be able to operate as a Telnet client. See "12.7 Setting Up IP Param-
eters" (p. 12-53) for more information about assigning IP parameters
to the Network Card.

Establishing a Telnet Connection

1
Start up the Telnet client.
2
Specify the IP address of the Network Card and connect.
3
At the login:
To check settings:
To change settings:
4
This displays the Main Menu shown below.
The Configuration Utility
Unit Serial no. 460121 V5.04
Main Menu
1. IP Parameters
2. LPD Printers
3. Protocols
4. Reset Unit
5. Restore Factory Defaults
Pi4700e
prompt, use one of the ID's shown below to log in.
ID
guest
sysadm
12
Password
guest
sysadm
12-61