Assigning Ip Addresses Using Arp (For Windows) - Minolta PI4700E User Manual

12

Assigning IP Addresses Using ARP (For Windows)

1
On a computer associated with the same network segment as the Dig-
ital Copier, click Start, point to Programs, and then click
Prompt (Command
2
Type the command shown below.
arp -s <IP address assigned to Network Card> <MAC
address>
Example:
Network Card MAC Address: 00:20:6b:aa:bb:cc
IP Address: 192.9.200.200
arp -s 192.9.200.200 00-20-6b-aa-bb-cc
This stores the MAC address and IP address data in the cache.
3
Next, type the command shown below.
ping <IP address assigned to Network Card>
Example:
IP address assigned to Network Card: 192.9.200.200
ping 192.9.200.200
This command sends the IP address to the Network Card. A timeout
message is returned until the Network Card recognizes this IP address
and restarts.
4
The Network Card waits for auto reset. Otherwise, restart the Digital
Copier.
5
After the Network Card restarts, type the command from step 3 again.
ping <IP address assigned to Network Card>
Example:
IP Address: 192.9.200.200
ping 192.9.200.200
Repeat step 5 until a response is returned. IP address assignment is
complete when a response is returned.
12-54
Prompt).
Setting Up IP Parameters
MS-DOS
Pi4700e