Macintosh configuration
8.6
Macintosh configuration
This chapter describes how to configure for network printing in a Macin-
tosh environment.
Setting Up AppleTalk
Use the following procedure to make AppleTalk settings.
1
On the Apple menu, point to
Talk.
2
Select Ethernet.
3
Close the AppleTalk dialog box.
Selecting and Setting Up the Printer
You must use the following procedure to configure the driver before print-
ing for the first time.
1
Install the PostScript printer driver and the PPD file for the Digital Copi-
er.
❍
See the documentation that comes with the Digital Copier for infor-
mation about how to install it.
2
Select
Chooser
3
Use the field in the upper left of the dialog box to select the appropriate
printer driver for your Digital Copier.
4
Use the field in the lower left of the dialog box to select the zone where
the Digital Copier is connected.
❍
You do not need to select a zone if your network is configured with-
out using zones.
5
In the printer list on the right side of the dialog box, select your Digital
Copier. The default name of this Digital Copier is MLT_<serial num-
ber>.
6
Click the
have a
Pi4700e
from the Apple menu.
Create
button. (If the dialog box on your screen does not
Create
button, click the
Control Panel
and then select
Setup
button instead.)
8
Apple-
8-27