Bsd System - Minolta PI4700E User Manual

12

BSD System

This section describes how to set up a remote printer on the host that
sends jobs to the Network Card using printer resident lpd. This is accom-
plished by adding an entry to the host's
you use.
1
Use an editor to open /etc/printcap.
2
Make entries that name the Network Card name as the remote host,
and assign any name to the remote printer.
The following is an example of typical printcap entries.
<printer name>:\
(Example: "lprprinter")
:lp=:\
rm=<remote host>:\
(Host name from /etc/hosts)
:rp=<remote printer name>:\
(Any name)
:sd=/usr/spool/lpd/<printer name>:
(Specifies spool directory for where the system can spool data and
perform other spool control.)
This entry sends jobs spooled in /usr/spool/lpd/<printer name> to the
printer specified by <printer name> for printing by the Network Card
specified by <remote host>.
3
Create the spooling directory.
mkdir /usr/spool/lpd/<printer name>
4
Use the lpr command to print something.
lpr -P<printer name> <file name>
Installation is complete if the file you specify prints correctly.
12-32
UNIX Configuration
/etc/printcap file for each printer
Pi4700e