Table of Contents
Advertisement
UNIX Configuration
12
Add any comments you want to the printcap file. For example, you
could type something like the following.
Dick's printer is down the hall.
13
Select
exit
procedure.
SCO UNIX
Use the following procedure to set up a remote printer on the host that
sends jobs to a Network Card using lpd.
1
At the prompt, type:
mkdev rlp
Note
You cannot run mkdev rlp twice. To add another printer, use the rlp-
conf command.
2
Type the responses shown below for the questions that appear.
Do you want to install or remove a remote printer?
Type:
I
3
Do you want to change printer description file /etc/printcap?
Type:
Y
4
Write a printer name.
Type the name of the printer.
Example:
5
Is lprprinter1 a remote printer or a local printer?
Type:
R
6
Enter remote host name.
Type the Network Card host name recorded in the printcap file.
Example:
7
Confirm the information you have entered.
Type:
Y
8
Confirm the preceding connection as your system default.
Type:
Y
Pi4700e
to save your settings and then press
lprprinter1
lprprinter
12
to complete the
Enter
12-37
Advertisement
Table of Contents
Troubleshooting
