Minolta PI4700E User Manual page 347

11
Symptom
Unable to staple
properly.
The stapling position
is opposite to what is
expected.
Unable to specify
Punch.
Unable to effect
Punch.
The hole punch posi-
tion is opposite to
what is expected.
11-4
Possible Cause
No stapling can be effected if the
type of paper is thick paper or
OHP transparencies.
When Mailbin Finisher or Multi-
staple Finisher is installed, no
stapling can be effected if num-
ber of prints to be made exceeds
50.
When Single-staple Finisher is
installed, no stapling can be ef-
fected if number of prints to be
made exceeds 30.
No stapling can be effected if the
number of pages to be printed is
50 or more when a Folding Fin-
isher is mounted. Center Staple
is also disabled if the number of
pages to be printed is 15 or
more.
No stapling can be effected if
original document contains pag-
es of different sizes.
The paper direction and N-up do
not match the setting made for
Orientation.
Either a Multi-staple Finisher,
Mailbin Finisher or Folding Fin-
isher must be mounted to enable
the setting of Punch, and "Multi-
staple Finisher", "Mailbin Finish-
er" or "Folding Finisher" must be
selected from "Installable Op-
tions" to specify Punch.
Punch cannot be specified if
Booklet or OHP interleaving is
specified.
No holes can be made if the type
of paper is thick paper or OHP
transparencies.
Prints can at times be fed out
without being punched if the di-
rection of the paper loaded in the
paper source is not appropriate.
The paper direction and N-up do
not match the setting made for
Orientation.
Unable to Print
Action
Check the type of paper.
Check the number of prints to be
made.
Change the setting for Orienta-
tion.
Select "Multi-staple Finisher"
"Mailbin Finisher" or "Folding
Finisher" from "Installable Op-
tions."
Check the setting of Booklet and
OHP Interleaving.
Check the type of paper.
Check the direction of the paper.
Change the setting for Orienta-
tion.
Pi4700e