As/400 - Minolta PI4700E User Manual

UNIX Configuration
5
Type the appropriate Network Card values on the window that ap-
pears.
The following table shows some sample settings.
Item
Printer Name
Remote System Name
Remote printer Name
6
From the three settings at the bottom of the window, select
Printer is on BSD
7
Click OK.
8
Ping the Network Card to check the connection.
ping <Network Card IP address>
When ping causes the message shown below to return, it means the
IP address is setup correctly.
<Network Card IP address> is alive.

AS/400

When working with the output queue description (WORKOUTQD), you
must provide information for a number of fields in order to allow the Net-
work Card to function properly as a remote printer device.
1
When prompted for the remote system, type
400 system recognizes the device as an IP device.
2
Input an appropriate name (like PORT1) for the remote printer queue
name.
3
Connection type
4
Internet address
5
Destination Type
6
In response to the message asking if you want to convert SCS to
ASCII, type YES.
This tells the AS/400 system to convert text.
7
For Manufacturer type and
comes with the printer controller.
Pi4700e
Example Input Data Description
Name used in the lp command
myprinter
Network Card host name recorded in
fastprint
hosts
lpd queue name (You can use any name you
PORT1
want here.)
System.
must be IP.
must be the Network Card IP address.
must be OTHER.
model, specify the printer driver that
12
/etc/
Remote
INTNETADR so the AS/
12-35