Downloading The System Software (Overwriting) - Canon imageRUNNER 7095 Service Manual

Chapter 18
F-18-53
MEMO:
If the system software in the USB device is found
to be of the same or older version, a message will
appear asking you if you want to overwrite. Go
though the instructions on the control panel, and
press the appropriate key.
[0]: overwrite / other than [0]: do not overwrite
F-18-54
5) While downloading is under way, the control
panel screen shows its progress. At the end of
downloading, a message will appear asking you
to press a key. Press the appropriate key. If the
machine is in normal mode, it starts the shut-
down instructions.
F-18-55
6) When a message appears asking you to turn off
the power, turn off the main power switch,
remove the USB device, and turn on the main
power switch.
18-20
7) Upon start-up, the machine starts to write the
system software to the system area of the HDD
or the flash ROM. At the end of writing to the
HDD, a message will appear asking you to turn
off and then back on the power. Turn off and
then back on the main power switch.
F-18-56
18.4.4.5 Downloading the System
Software (overwriting)
[3]: Upgrade (Overwrite all)
The system software in the USB device will over-
write the software on the HDD regardless of the
version of the latter. Unlike menu item [1], how-
ever, the machine will not restart on its own at the
end of downloading. When the power is turned
off and then back on manually, the machine starts
writing the system software.
<Procedure>
1) If the machine is on, go through the HDD shut-
down instructions, and turn off the main power.
2) Connect the USB device to the USB port.
3) Put the machine in download mode (normal or
safe).
4) Go through the instructions on the control
panel, and press the appropriate key.
[3] -> [0]: execute download / other that [0]: go
back to Menu screen
F-18-57
0011-6780