Canon imageRUNNER 7095 Service Manual page 534

Chapter 17
*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).
**: model equipped with DADF-M1 (outside Japan: iR7086).
Sub item
JOB- Use it to set job intervals for an interrupt.
INVL
settings
0: continue with next job immediately for interrupt (default)
1: start next job after delivery of last sheet of interrupt
2: start next job after last sheet of all jobs
LGSW- Use it to enable/disable display of 'enable/disable log indication' for user mode.
DSP
settings
0: do not display (default); 1: display
PCL- Use it to set PCL command COPIES Meru/Pinatubo/Hood compatibility.
COPY
settings
0: control on page basis according to COPIES command set on each page (default)
1: Meru/Pinatubo/Hood compatibility mode; 2 through 65535: for future expansion
PRJOB- Use it to make CCV count pulse settings for reception and report output.
CP
settings
0: do not generate count pulse (default); 1: generate count pulse
DPT-ID-7 Use it to enable/disable group ID registration and 7-character authentication input.
settings
0: normal (default); 1: 7-cahrceter input
RUI-RJT Use it to cut the HTTP port in response to 3 attempts at illegal authentication from a remote UI.
settings
0: disable (default); 1: enable
CTM-S06 Use it to enable/disable deletion of the password from an export file with a file transmission
address.
settings
0: do no delete (default); 1: delete
FREG- Use it to enable/disable display of the free area of the MEAP counter (SPEED).
SW
settings
0: do not display (default); 1: display
IFAX- Use it to set restrictions on transmission sizes for i-fax transmission.
SZL
settings
0: set restrictions; 1: do not set restrictions (only if not through server; default)
IFAX- Use it to enable/disable page division for transmission in i-fax simple mode (when the data
PGD exceeds the upper limit for transmission size).
settings
0: do not permit (default); 1: permit
MEAPSA Use it to switch to MEAP safe mode.
FE
settings
0: normal mode (default); 1: safe mode
If it is set to '1', the notation "MPSF" will appear at the top of the screen.
TRAY- Use it to set the notification mechanism used in response to a tray full condition.
FLL
settings
0: issue when all available trays are full
1: when special trays are full
PRNT- Use it to specify whether or not to suspend subsequent jobs when the ongoing job is cancelled
POS in the presence of an error.
Enables/disables suspension of subsequent jobs when a job cancel (e.g., #037) has occurred
because of an error (other than a service call) during PDL printing.
settings
0: do not suspend; 1: suspend
17-72
COPIER > OPTION > USER
Description Level
2
2
2
2
2
2
2
2
2
2
2
2
2