Chapter 7
7) Remove the E-ring [1], gear [2], pressure roll
[3], washer [4], grip ring [5], seal [6], butting
roll [7], washer [4], and bearing [8] in the order
indicated.
[4]
[3]
[2]
[1]
F-7-91
8) Remove the E-ring [1] and the pressure arm [2]
at the front.
F-7-92
9) Remove the C-ring [1], washer [2], pressure
roll [3], seal [4], washer [2], butting roll [5], C-
ring [1], and bearing [6]; the, remove the two
screws [7], and detach the bushing [8] and then
the developing sleeve [9].
[9]
[8]
[6]
[1]
[5]
F-7-93
Do not leave fingerprints or oil on the surface of
the developing cylinder. Wipe off any with lint-
free paper. (Do not use solvent.)
7-44
[8]
[4]
[7]
[6]
[5]
[2]
[1]
[7]
[2]
[4]
[3]
[2]
[1]
Points to Note When Mounting the Devel-
oping Cylinder
Both front and rear sides of the developing as-
sembly and the developing cylinder are equipped
with a magnetic seal plate [1].
When mounting the developing cylinder, take
care not to bring the magnetic seal plate into con-
tact with the surface of the cylinder to avoid dam-
age.
[1]
F-7-94
7.10.11 Developing Blade
7.10.11.1 Before Starting the Work
1) Open the manual feeder tray cover.
2) Remove the pull-off roller unit.
3) Remove the developing assembly stay.
4) Remove the developing assembly.
5) Remove the hopper.
7.10.11.2 Removing the Blade Unit
1) Remove the four mounting screws [1], and
detach the sleeve cover [2].
F-7-95
[1]
[2]
0011-7947
0010-8872