Charging Wire - Canon imageRUNNER 7095 Service Manual

11) Mount the wire cleaner. At this time, pay
attention to the orientation of the wire cleaner.
12) Wipe the charging wire with lint-free paper
moistened with alcohol.
7.10.19.5 Stringing the Grid of the
Primary Charging Assembly
1) Check to make sure that the 4 screws used to
keep the front/rear block and shielding plate are
not loose.
Then, hook the end of the charging wire on stud
A, and then route it for 41 runs; then, hook it on
B, C, and D; thereafter, fit it between the double
washers [1], give a 1/2 turn around the screw
[2], and secure it in place.
B
C
D [1]
[2]
F-7-138
2) Loosen the screws [1], [2], [3], [4]; then,
tighten the screw [5] to a torque of 1.5 -/+0.2
kg-cm. thereafter, tighten the screws [1], [2],
[3], [4] to a torque of 8 kg-cm in the order
indicated.
[3]
[4]
[1]
[2]
F-7-139
0010-8942
A
[5]
7.10.19.6 Adjusting the Height of the

Charging Wire

Height of charging wire
Primary
- 0mm
7.5
+3mm
Pre-transfer
No height adjusting
mechanism
13.6 ±0.3mm
Separation
17.0 0.2mm
Transfer
MEMO:
The height (position) of the primary and transfer
charging wires may be adjusted by turning the
screw found at the rear of the charging assembly.
A full turn of the screw changes the position of
the charging wire by about 0.7 mm.
Chapter 7
T-7-3
- 0mm
7.5
+3mm
15.5 0.2mm
0010-8945
7-53