Lifter Drive Assembly; Main Drive Assembly - Canon imageRUNNER 7095 Service Manual

Chapter 10

10.5.7 Lifter Drive Assembly

10.5.7.1 Removing the Lifter Drive
Assembly (right deck)
Construction
F-10-19
1) Remove the rear cover.
2) Remove the high-voltage PCB unit.
3) Remove the flywheel.
4) Remove the drum gear.
5) Remove the waste toner pipe.
6) Remove the screw, and loosen the harness
guide [1]; disconnect the two connectors [2],
and remove the four screws [3]; then, detach
the lifter drive assembly (for the right deck) [4].
[1]
[4]
[3]
F-10-20
10.5.7.2 Removing the Lifter Drive
Assembly (left deck)
Construction
F-10-21
1) Remove the rear cover.
2) Open the main controller box assembly.
3) Remove the DC controller assembly.
10-12
[3]
[2]
[2] [3]
4) Disconnect the three connectors [1], and
remove the four screws [2]; then, detach the
lifter drive assembly (for the left deck) [3].
[1]
0010-9594

10.5.8 Main Drive Assembly

10.5.8.1 Removing the Main Drive
Assembly
Construction
1) Remove the rear cover.
2) Remove the high-voltage PCB unit.
3) Remove the flywheel.
4) Remove the drum gear.
5) Remove the waste toner pipe.
6) Remove the drum drive assembly.
7) Remove the waste toner drive assembly.
8) Disconnect the two connectors [1], and remove
the nine screws [2]; then, detach the main drive
0010-9596
assembly [3].
[2]
[2]
[2]
[2]
[1] [3]
F-10-22
F-10-23
[2]
[1]
[2] [3] [2]
F-10-24
[1]
[2]
0010-9599
[2]