Adjusting The Lead Edge Registration; Setting The Cassette; Correcting The Skew - Canon imageRUNNER 7095 Service Manual

2.2.18 Adjusting the Lead Edge
Registration
1) Make the following selections in service mode
so that the image margin will be as indicated:
COPIER > ADJUST > FEED-ADJ > REGIST.
- if the margin is too large, increase the setting
of REGIST (a change of 10 will decrease the
margin by 1 mm).
- if the margin is too small, decrease the setting
of REGIST (a change of 10 will increase the
margin by 1 mm).
Lf=4.0+1.5/-1.0
0 0
2 2
4 4
6 6
8 8
10 10
F-2-116

2.2.19 Setting the Cassette

1) Press the release button of cassette 3/4, and
slide out the cassette.
2) Fit the side guide plate [1] in the hole (A4/A3)
identified by the marking M [2].
[1]
[2]
F-2-117
3) Fit the included inch block from inside the
cassette so that the hole (STMT-R) of marking
A [1] and the hole (LTR-R) of marking H [2]
are covered.
0011-3857
Lf
0010-8964
- Be sure there is no gap.
- Perform the foregoing steps if the user is going
to use AB series sheets only.
F-2-118
4) Put the cassettes back in the machine.

2.2.20 Correcting the Skew

If paper from the left/right deck moves askew, go
through the following:
1) Loosen the 2 screws [1].
2) Push the side guide plate (front) [2] against the
paper.
[2] [1]
F-2-119
3) With the side guide plate (front) against the
paper, tighten the screw.
Chapter 2
[1]
[2]
0011-4484
2-29