Internal Delivery Roller; Main Thermistor - Canon imageRUNNER 7095 Service Manual

Chapter 9
5) Remove the E-ring [1], one-way gear [2], and
bearing [3] at the rear of the external roller
shaft; then, remove the 2 Erings [4] and the 2
rollers [5] of each roller.
[5]
[4]
[3]
F-9-34
Take care not to lose the parallel pin used in each
roller.

9.5.5 Internal Delivery Roller

9.5.5.1 Removing the Internal Delivery
Roller
1) Remove the fixing assembly.
2) Remove the internal delivery roller [1], bearing
[2], 3 E-rings [3], and bushing holder [4]; then,
detach the drive gear [5].
[1] [4]
F-9-35
3) Remove the E-ring [1] and the bushing [2] at
the rear of the shaft; then, detach the internal
delivery roller [3].
F-9-36
9-16
[5]
[4]
[2]
[1]
[3]
[2]
[5]
[3]
[3]
[2]
[1]

9.5.6 Main Thermistor

9.5.6.1 Removing the Main Thermistor
1) Remove the fixing assembly.
2) Remove the fixing web and the oil pan.
3) Remove the fixing harness cover.
4) Disconnect the connector [1] of the thermistor.
Remove the screw [2], and shift the thermistor
assembly [3] to the rear to detach.
When shifting the thermistor assembly to the rear,
take care not to damage the fixing roller with the
thermistor.
0010-9398
5) Remove the 2 thermistor retaining springs [1],
and detach the main thermistor [2].
9.5.6.2 Mounting the Main Thermistor
When mounting the main thermistor to the fixing
assembly, be sure that the tie-wrap [1] is as
shown.
The tie-wrap serves as a stopper by butting
against the claw [2].
Check also to be sure that the main thermistor and
the fixing roller are not away from each other.
[2]
[2]
[3]
[1]
F-9-37
[1] [2]
[1]
F-9-38
[1]
F-9-39
0010-9399
0010-9400