Canon imageRUNNER 7095 Service Manual page 533
Hide thumbs
Also See for imageRUNNER 7095:
- Brochure & specs (8 pages) ,
- Specifications (4 pages) ,
- Driver manual (180 pages)
Table of Contents
Advertisement
*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).
**: model equipped with DADF-M1 (outside Japan: iR7086).
Sub item
DATE-
Use it to switch between date notations.
DSP
settings
0: YYMM/DD; 1: DD/MM/YY; 2: MM/DD/YY
MB-CCV Use it to set restrictions on the individuals permitted the use of mail box control card.
settings
0: do not restrict (default); 1: restrict
PR-D-
Use it to set the density for printing (PDL input).
SEL
settings
0: (light) <->4 (standard; default) <-> 8 (dark)
TRY-STP Use it to set the output interrupt mode used in response to a tray full condition.
settings
0: normal mode (suspend when finisher tray becomes full; default); 1: suspend in relation to
height
MF-LG-
Use it to set extra length mode key.
ST
settings
0: normal (default); 1: indicate extra length key on supported mode screen
SPECK-
Use it to enable/disable display of a warning message in response to the result of dust detection
DP
for stream reading.
settings
0: do not indicate; 1: indicate (default)
CNT-
Use it to enable/disable the indication of a serial number in response to a press on the counter
DISP
check mode.
settings
0: indicate (default); 1: do not indicate
PH-D-
Use it to specify the number of lines for photo mode.
SEL
settings
0: 141 lines (default); 1: 134 lines
OP-SZ-
Use it to enable/disable the original size detection function in reference to the opening of the
DT
copyboard cover.
The machine may be set so that it detects the size of an original with the copyboard cover open
(e.g., for a book).
settings
0: off (default); 1: on
If set to '1', the machine executes original size detection in response to a press on the Start key.
NW-
Use it to enable/disable the network scan function.
SCAN
settings
0: do not permit; 1: permit
This choice is not available on a Japanese model. For a non-Japanese PS/PCL model, the
settings is fixed to '1'.
INS-C/S
Use it to expand the inserter function.
settings
0: support only cover (default); 1: support multi-inserter (cover + interleaf)
TBIC-
Use it to enable/disable halftone uneven density reduction mode.
RNK
settings
1 to 5 (default: 2)
HDCR-
Use it to switch between HDD deletion modes.
DSP
settings
1: once using 0s (default); 2: once using random data; 3: 3 times using random data
BCK-
Use it to enable/disable the back cover function.
CVR
settings
0: off; 1: on
COPIER > OPTION > USER
Description
Chapter 17
Level
2
2
2
2
2
2
2
2
2
2
2
2
2
2
17-71
Advertisement
Chapters
Table of Contents
