Canon imageRUNNER 7095 Service Manual page 536
Hide thumbs
Also See for imageRUNNER 7095:
- Brochure & specs (8 pages) ,
- Specifications (4 pages) ,
- Driver manual (180 pages)
Table of Contents
Advertisement
Chapter 17
Sub item
CST-U3
Use it to specify the name of paper in a paper size group (U3).
When any of the special size papers is specified for U3, the paper may be used as a special size
paper for U3 (universal cassette).
settings
25: Australian Foolscap; 34: Government Legal (default); 35: Folio
CST-U4
Use it to specify the image of paper used in a paper size group (U4).
When any of the following special size papers is set for U4, the paper may be used as a special
size paper for U4 (universal cassette).
settings
18: LTR (default); 29: Argentine Letter
<ACC>
Sub item
COIN
Use it to set the coin vendor mechanism.
settings
0: coin vendor not used (default); 1: coin vendor used; 2: remote counter
DK-P
Use it to specify the size of the paper in the side paper deck (small).
settings
0: A4 (default); 1: B5; 2: LTR
PD-SIZE Use it to specify the size of the paper in the side paper deck (large).
settings
0: as set in user mode (default); 22: Korean Government; 23: Korean Government-R; 24:
Foolscap; 25: Australian Foolscap; 26: Officio; 27: Ecuadorian Officio; 28: Bolivian Officio;
29: Argentine Letter; 30: Argentine Letter-R; 31: Government Letter; 32: Government Letter-
R; 33: Argentine Legal; 34: Government Legal; 35: Folio; 36; Argentine Officio; 37: Mexican
Officio
This mode item is indicated only when a large paper deck is connected.
TRM-
Use it to enable/disable display of the message for replacement of the trimmer blade on the
CTR
user screen
settings
0: do not display (default); 1: display
TRM-
enabling/disabling display of the trimmer blade replacement message on the user screen
CTRH
settings
0: do not display (default); 1: display
BND-
for future use
CTR
BND-
for future use
CTRH
CC-
Use it to change the I/F support level for the control card (CC IV/CC V).
SPSW
settings
0: do not support (default); 1: support (priority on speed); 2: support (control by priority on
upper limit)
If set to '1',
suspension of printing may not be accurate based on the upper limit owing to the priority given
to the maintenance of performance of the printer engine.
If set to '2',
suspension of printing is possible based on the upper limit, but the printer engine performance
may drop depending on which source of paper is selected.
17-74
COPIER > OPTION > CST
Description
T-17-51
COPIER > OPTION > ACC
Description
Sub
item
2
2
Level
1
1
1
1
1
1
1
2
Advertisement
Chapters
Table of Contents
