Drum Drive Assembly - Canon imageRUNNER 7095 Service Manual

When mounting the main drive assembly, be sure
to slide out the fixing/feeding assembly in ad-
vance. (A coupling and a spring are mounted to
the back of the main drive assembly. If the fixing/
feeding assembly is inside, the action of the
spring will hinder mounting work.)

10.5.9 Drum Drive Assembly

10.5.9.1 Removing the Drum Drive
Assembly
1) Remove the HV-DC PCB.
2) Remove the 2 screws [1], and detach the
flywheel [2].
[1]
F-10-25
3) Loosen the 2 screws [1] (w/ hex hole), and
remove the binding screw [2] (w/spring); then,
detach the gear [3] of the drum shaft.
[1]
[1]
F-10-26
When removing the screw from the drum shaft
gear, be sure to pay attention to the direction of
gear rotation, i.e., turn it counterclockwise.
0010-9601
[2]
[2]
[3]
4) Remove the water toner case; then, remove the
5 screws [1], and disconnect the 4 connectors
[2] to detach the waste toner case base [3].
[1] [2] [3]
[1]
F-10-27
5) Remove the E-ring [2] at the tip of the waste
toner pipe [1], and shift the bushing [3] up to
remove the 2 screws [4]; then, detach the waste
toner pipe [1].
[1]
F-10-28
Chapter 10
[1]
[2] [2]
[2]
[3]
[4]
10-13