Chapter 13
13.3.4 Points to Note About Schedule Servicing
- Make a thorough check to see that there is no melting, thermal deformation, cracking, or discoloration
(yellowish) caused by leakage in the block (front, rear). If any abnormal condition is noted, replace it
with a new one as soon as possible.
- Be sure to check and clean all the way, including the inner side of the block (front, rear).
- Never use a cloth with any metal particles.
- Do not use a moist cloth for areas other than those for which doing so is specifically mentioned. If alcohol
has been used, be sure it has dried completely before putting the part back into the machine.
- Whenever possible, perform scheduled servicing and replacement at the indicated intervals.
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[10]
[11]
[12]
13-12
F-13-13
0010-9515
[13]
[14]
[15]
[16]
[17]
[18]
[19]
[20]
[21]
[22]