Canon imageRUNNER 7095 Service Manual page 523

*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).
**: model equipped with DADF-M1 (outside Japan: iR7086).
Sub item
TR-SP- Use it to change the transfer/separation output setting for pickup from the left deck.
C2
settings
0: plain paper (defeat); 1: recycled paper; 2: tracing paper
TR-SP- Use it to change the transfer/separation output setting for cassette 3.
C3
settings
0: plain paper (default); 1: recycled paper; 2: tracing paper
TR-SP- Use it to change the transfer/separation output setting for pickup from cassette 4.
C4
settings
0: plain paper (default); 1: recycled paper; 2: tracing paper
TR-SP- Use it to change the transfer/separation output setting for pickup from the manual feeder tray.
MF
settings
0: plain paper (default); 1: recycled paper; 2: tracing paper
TR-SP- Use it to change the transfer/separation output setting for pickup from the side paper deck.
DK
settings
0: plain paper (default); 1: recycled paper; 2; tracing paper
DEV- Use it to enable/disable the developing cylinder speed variation mechanism.
SLOW
settings
0: change to suit environment; 1: high speed; 2: low speed (default)
W/SCNR Use it to indicate the presence/absence of a reader unit.
settings
0: printer model (w/o reader); 1: copier model (w/ reader)
If the reader unit is detected at start-up, '1' will be set automatically.
STPL- Use it to enable/disable offset stacking in stapler mode.
SFT
settings
0: use offset stacking in stapler mode (default)
1: do not use offset stacking in stapler mode
The foregoing choice is valid only when 1-point stapling is used.
DFDST- Use it to adjust the dust detection level when the ADF is in use. (sheet-to-sheet correction)
L1
A higher setting will make the mechanism more sensitive, detecting finer particles of dust.
settings: 0 to 255
DFDST- Use it to adjust the dust detection level when the ADF is in use. (post-job detection)
L2
A higher setting will make the mechanism more sensitive, detecting finer particles of dust.
settings: 0 to 255
CCD- Use it to indicate whether or not to use data for CCD gain correction.
LUT *
Indicates whether or not to use the data collected by COPIER > FUNCTION > CCD > LUT-
ADJ2.
settings
0: do not use; 1: use (1-point correction); 2: use (3-point correction)
ENVP- Use it to set the intervals at which the history data is collected on the machine inside
INT temperature/fixing temperature.
settings: 0 to 480 (unit: min)
If '0', the history data is not collected.
BASE- Use it to switch from the MEAP full model to the base model.
SW
settings
0: off (base model); 1: on (full model)
SC-L- Use it to set the threshold for identifying large size paper for the scan counter.
CNT
settings
0: B4 (default); 1: LTR
COPIER > OPTION > BODY
Description
Chapter 17
Level
1
1
1
1
1
1
1
1
1
1
1
1
1
1
17-61