Adjusting The Left/Right Non-Image Width; Adjusting The Leading Edge Non-Image Width; Scanning System; When Replacing Components Of The Scanning System - Canon imageRUNNER 7095 Service Manual

Chapter 14
14.2.5 Adjusting the Left/Right Non-Image
Width
1) Adjust the non-image width in service mode so
that it is as indicated: COPIER > ADJUST >
ADJ-XY > ADJ-Y.
[1] Edge of image
- Decreasing the ADJ-Y setting: A decrease by
'10' will decrease the margin by 1 mm.
- Increasing the ADJ-Y setting: An increase by
'10' will increase the non-image width by 1 mm.
[1]
Wl
0
2
4
6
8
10
F-14-25
14.2.6 Adjusting the Leading Edge Non-
Image Width
1) Adjust the non-image width in service mode so
that it is as indicated: COPIER > ADJUST >
ADJ-XY > ADJ-X.
[1] Image leading edge
- Decreasing the ADJ-X setting: A decrease by
'10' will decrease the width by 1 mm.
- Increasing the ADJ-X setting: An increase by
'10' will increase the width by 1 mm.
F-14-26
14-14

14.3 Scanning System

0011-8648
14.3.1 When Replacing Components of
<Components>
CCD unit, copyboard glass, scanning lamp,
standard white plate, inverter PCB
<Procedure>
Execute the following service mode item:
1) COPIER> FUNCTION> CCD> CCD-ADJ
(shading correction based on the standard white
plate)
14.3.2 When Replacing Components of
<Components>
CCD unit, copyboard glass, stream reading glass,
scanning lamp, inverter PCB
<Procedure>
Execute the following service mode items:
1) COPIER> FUNCTION> CCD> CCD-ADJ
(shading correction based on the standard white
plate)
2) COPIER> FUNCTION> CCD> DF-WLVL1
(ADF white level; for copyboard mode)
3) COPIER> FUNCTION> CCD> DF-WLVL2
(ADF white level; for stream reading mode)
0011-8649
14.3.3 Adjusting the Position of the No. 1/
1) Arrange the mirror positioning tool (FY9-
3009-040) so that it is ready for use in the
machine (by changing the pin position; REAR).
[1]
the Scanning System <iR7105/7095>
the Scanning System <iR7086>
No. 2 Mirror Base
[C]
[B]
[A]
F-14-27
0011-8722
0011-7996
0011-9468
[A]
[B]