Canon imageRUNNER 7095 Service Manual page 322

Chapter 10
Conditions Initiating a Shift Back to Standby Mode (low power -> standby)
- press on Power Save key
- press on control panel power switch
MEMO:
If the same setting is used for both 'low power mode shift interval' and 'auto sleep time', a shift is made to
sleep mode if a specific period of time passes from a standby state (i.e., no shift takes place to low power
mode).
4. Sleep Mode
The machine's sleep mode consists of 'sleep mode 1' (high rate of power saving in sleep) and 'sleep mode
3' (low rate of power saving in sleep), and the selection of one over the other depends on how the machine
is set and the presence/absence of paper.
Conditions Initiating a Shift (standby/power save/low power -> sleep)
- The machine remains in a standby state for a specific period of time (variable through 'auto sleep time'
in user mode; default: 60 min).
- The control panel power switch is turned off while the machine is in a standby state.
When a condition has occurred activating a shift to a sleep state, the machine drives the heat discharge fan
for a specific period of time (6 min) to cool the inside of the machine and then enters sleep mode.
Conditions Initiating Standby Mode (sleep -> standby)
- press on the control panel power switch
5. Power-Off Mode
The machine enters and remains in power-off mode when its main power switch is turned off.
To return from power-off mode, the machine's main power switch must be turned on, in response to which
it will automatically return to standby mode.
10-8