Canon imageRUNNER 7095 Service Manual page 81

Chapter 2
11) Remove the upper front cover unit lower
cover [1].
- 8 screws [2]
[2]
[2]
F-2-132
12) Remove the card reader base [1].
- screw [2]
F-2-133
13) Remove the face plate [2] from the card
reader base [1].
- 2 screws [3]
(The removed part will be used in step 18).)
F-2-134
14) Remove the 2 screws [1] from the top of the
card reader base.
15) Mount the card reader [3] using the 2 screws
[2] used to hold the face plate in place and the
2 screws [1] you have removed previously.
16) Route the harness [4] and the grounding wire
[5] under the card reader as shown and through
the edge saddle [6].
2-34
[1]
[2]
[2]
[1]
[3]
[2]
[1]
[1]
[4]
[5]
[6]
F-2-135
17) Remove the toothed screw [1] from the rear
of the card reader base.
Fix the grounding wire [2] in place using the
toothed screw [1] you have removed.
[1]
F-2-136
18) Remove the 2 screws [1] from the front of the
card reader base.
Change the orientation of the face plate [2] you
have removed in step 13), and fix it in place
using 2 screws [1] you have removed
previously.
F-2-137
[3]
[2]
[2]
[2]
[1]
[2]
[1]